Tour to Greece - your dream come true!
Greece is a wonderful country! This direction has always been popular and relevant, both among young vacationers and older tourists. The high demand for tours to Greece is due to…

Continue reading →

IQ Option http://www.iqoption.com.bd/ বাংলাদেশে
Family holidays in Vityazevo
If you want to spend your holidays at sea with children, then there is no better place than Vityazevo! The beach strip is up to 200 meters wide with golden…

Continue reading →

The scariest places in the world
There are many mystical places on earth that cause fear and horror in people. They are filmed in photos and videos, legends tell about them, make ratings of the worst…

Continue reading →

Correct installation of the protective strip for the keel of the vessel

Polyurethane plastic linings protect the stem and keel of the vessel from damage when mooring to the shore and climbing onto the trailer.

The advantages of such a tape are its ease of installation, it has a long service life and it is not necessary to repair a damaged keel every year.

PROTECTIVE TAPE INSTALLATION STAGES
It is important to remember that the quality of bonding depends on the surface quality of the keel of the vessel.

If a poor-quality gelcoat repair has been completed or antifouling paint has been applied, this will lead to peeling of the protective strip together with the paint and gelcoat layer.

CLEANING
It is necessary to clean the keel of the vessel from dirt, algae and wax (if any), and the protective strip from dust. If the bottom is cleaned well, then gluing will not cause difficulties.

DEGREASING
It is important to degrease the protective strip itself and the place of gluing. This can be done with alcohol or acetone.

APPLICATION OF ADHESIVE
Glue needs to be applied with a thin layer. The main thing is to carefully lubricate everything: the edges of the bottom and redans.

ADHESIVE
Straighten the protective strip before gluing. Put the film in the sun for 10 minutes. If the air temperature is below 16-18 degrees, then lightly heat the film with an industrial hairdryer. All this will make installing a protective film easier.

Bonding start from the bow of the boat. Follow the recommendations of the adhesive manufacturer.

Protect the keel of the vessel with a polyurethane protective film and then you will not have to repair damage every time after use.

Israel Travel News
ISRAELI BORDER ACCESS SYSTEM In February 2013, the Israeli authorities greatly simplified and accelerated the procedure for entering the country. The new system works successfully and concerns not only incoming…

...

Family holidays in Vityazevo
If you want to spend your holidays at sea with children, then there is no better place than Vityazevo! The beach strip is up to 200 meters wide with golden…

...

How profitable to buy a tour?
Probably, every person living in Russia, whoever he is, will not miss the opportunity to save. This principle works even when a long-awaited vacation is planned. Any tourist wishes to…

...

Welcome to Cyprus!
The island of Cyprus is a hospitable and safe country, charming with its picturesque nature, pristine beaches and magnificent architectural monuments. If you bought a tour to Cyprus to spend…

...